WASHINGTON — Federal aviation authorities expect to announce this week the underlying cause of an outage that triggered a nationwide ground stop for flights on Nov. 13, according to reports from FOX 35 Orlando and CNN.
Transportation Secretary Sean Duffy is set to brief the public on the official findings, Federal Aviation Administration Administrator Bryan Bedford said Thursday. The technical breakdown disrupted radar feeds and communications at 17 of the country’s 22 regional air traffic control centers, which direct high-altitude flights. Departures were halted across the nation for more than four hours, affecting roughly 3,500 airplanes that were already airborne when the order was issued.
Router Replacement in Arkansas
Officials connected the widespread failure to telecom upgrades at an FAA location in El Dorado, Arkansas. Private contractor L3Harris Technologies was replacing older copper lines with fiber-optic cables at the site, FOX 35 Orlando reported. During the work, a newly added Juniper Networks router flooded the agency’s data network.
Duffy said a separate system in Amarillo, Texas, where hardware was swapped approximately three weeks earlier, also began flooding the network with data traffic. Though 68 earlier router installations occurred without incident, the FAA suspended further Juniper router upgrades while diagnostic testing continues. Hewlett Packard Enterprise, the parent company of Juniper Networks, stated that its equipment operated as configured.
Duffy told reporters that investigators were working to determine why the new router overwhelmed the network, noting that the trouble should have been detected and isolated much faster. Authorities are examining whether the disruption stemmed from faulty hardware, an installation mistake, or a configuration error.
Debate Over Contractor Oversight
The shutdown has ignited a debate over oversight during contractor maintenance. Bedford initially defended the FAA’s procedures, stating that the L3Harris worker “was monitored by an FAA technician” and that a risk assessment was completed before the upgrade, CNN reported.
However, union leaders and sources familiar with the facility disputed that account. Elizabeth Doherty, a spokesperson for the Professional Aviation Safety Specialists union, told CNN that the technician was instructed only to unlock the door for the contractor and had “no direction to help or assist in any way.” Doherty added that no union-represented employee conducted a risk assessment for the installation.
FAA spokeswoman Hannah Walden later clarified in a statement to CNN that the agency escort was responsible for giving the contractor access to the building. Walden explained that because the equipment belonged to L3Harris, the escort was not required to stay while the technician performed the work.
According to internal documents cited by CNN, a March 2025 FAA memo altered maintenance protocols, transitioning the agency from formally approving contractor maintenance requests to accepting simple notifications of upcoming work. Union sources said the change reduced direct government supervision, while the FAA stated the policy adjusted work priorities without reducing oversight standards.
Investigation Continues
L3Harris stated that it is cooperating fully with federal investigators to determine what conditions triggered the Nov. 13 outage. As Duffy prepares to reveal the root cause findings, officials continue testing network infrastructure to prevent similar nationwide flight groundings.



