WASHINGTON — The Federal Aviation Administration has halted the installation of new network routers and disabled key network features following a widespread ground stop that caused thousands of flight cancellations nationwide last week, the agency confirmed Tuesday.
The decision comes after an agency upgrade triggered severe telecommunications failures on Friday, forcing officials to temporarily ground flights across the country. FAA officials said the initial disruption stemmed from the setup of a new router in El Dorado, Arkansas, which flooded the telecommunications system with data and overwhelmed older infrastructure.
Network Disruption Traced to Upgrade Project
Transportation Secretary Sean Duffy said during an interview with ABC’s “This Week” on Sunday that the problem began while replacing outdated copper wiring with fiber-optic cables. When engineers activated a newly installed router in Arkansas, a separate system in Amarillo, Texas, that had been replaced three weeks earlier also began flooding the network with data.
The cascading data flood affected systems across 17 of the nation’s 22 regional air traffic control centers, which direct high-altitude aircraft traffic, according to Duffy. In response, the FAA instituted a nationwide ground stop lasting approximately four hours out of an abundance of caution, leading to more than 10,000 flight cancellations.
To prevent further outages, the FAA confirmed on its website Tuesday that it immediately disabled the originating functionality on the Arkansas router. “As a precaution, we disabled the same functionality on more than 60 other Juniper routers in the system, and we have paused installing them,” the agency stated.
Lawmakers Demand Answers and Scrutinize Funding
The installation pause aligns with demands from Capitol Hill. A group of 13 Democratic senators on the Senate Commerce Committee, led by Sen. Maria Cantwell, sent a letter to the FAA on Tuesday urging an immediate halt to router replacements until safety and reliability concerns are addressed. The contractor L3Harris is working to convert 3,648 routers to Juniper devices as part of the broader copper-to-fiber transition. Lawmakers noted that about 400 of those devices have been installed so far, with 69 currently operational.
The incident has also sparked a political battle over funding for the modernization of U.S. air traffic control infrastructure. The Trump administration and Secretary Duffy are requesting $50 billion from Congress to overhaul aging technical systems, increasing a previous request for $30 billion.
However, lawmakers from both parties have expressed skepticism regarding the emergency request, pointing out that Congress approved $12.5 billion for air traffic control upgrades last year. Senate Majority Leader John Thune noted that only about $4 billion of those funds had been spent, with roughly $8 billion remaining available. Data from the Department of Transportation indicated that $3.7 billion has been spent, while other funds remain tied to existing contracts and planned projects.
Investigations Underway
The affected equipment from Arkansas and Texas is currently undergoing analysis at an L3Harris laboratory in Florida to determine the precise root cause of the system failure. The FBI confirmed Tuesday that it is working with the FAA, the Department of Transportation, and L3Harris to investigate the outage, though federal law enforcement has not taken physical custody of the hardware.
Meanwhile, equipment manufacturer Hewlett Packard Enterprise, which owns Juniper Networks, said its devices worked properly during the incident. A company spokesperson stated that the router operated according to how installers configured it and did not fail or behave improperly.
Duffy is scheduled to meet behind closed doors with Senate Republicans on Tuesday to present a detailed accounting of what caused the ground stop and explain the administration’s expanded funding request. The FAA stated its installation pause will remain in place while the joint investigation continues.



